Dishwasher displays F Error Code number– Troubleshoot

Issue

Dishwasher displays Error Code

Applies to

• Dishwasher

Solution

If there is a malfunction, the dishwasher will display error codes to identify these.

• FF – Water inlet system failure - See link to article for troubleshooting advice
• F1 – Overflow – turn tap off and Contact for service
• F2 – Inability to discharge water - See link to article for troubleshooting advice
• F3 -Continuous water input - Contact for service
• F5 – Pressure system fault detected - Contact for service
• F6 – Faulty heater sensor - Contact for service
• F7 - Overheating - Contact for service
• F8 – Heater Error – Contact for service
• F9 – Diverter position error – contact for service

• HI – High voltage failure

When main supply voltage is above 285VAC, voltage sensing circuit detects high voltage and program is stopped by software, after main supply voltage is below 275VAC, program starts again

• LO – low voltage failure

When main supply voltage is below 145VAC, voltage sensing circuit detects low voltage and program is stopped by software, after main supply voltage is above 155VAC, program starts again

If voltage is low or high for 3 hours or more, at the end of the 3 hours: the Programs go to failure routine without draining.

Contact an Authorized Service Centre.

If the above steps don't resolve the issue, we recommend contacting an Authorized Service Center.