Dishwasher displays Error FF

Issue

Dishwasher displays Error FF

Applies to

• Dishwasher

Solution

FF – Water Inlet System Failure

Check the following

• Does the water pressure meet the minimum requirement: The pressure supplied by the tap should be at a minimum of 0.03 MPa. and at a maximum of 1 MPa.

If the water pressure is above 1 MPa, a pressure-relief valve should be installed

• If connected to hot inlet, a water tempering valve is required if the water temperature is over 60°C
• Make sure the water inlet tap is open, and water is flowing.
• Check and confirm correct installation of the inlet hose ensuring the hose is not kinked.
• In order to pass the safety valve through the kitchen cabinets, an opening of at least 45mm x 90mm is needed.

NOTE: Aquastop inlet hose has components using 240V. Do not cut Aquastop inlet hose. Do not let it get folded, twisted, kinked or crushed.

First, always disconnect the appliance from the power supply.

Separate the inlet hose from the tap and clean the filter of the hose.

Important Note: Only turn the locking nut to separate the hose from tap or to re secure the hose - do not turn the hose

Contact an Authorized Service Centre.

If the above steps don't resolve the issue, we recommend contacting an Authorized Service Center.